Emerson PACSystems RSTi-EP User Manual page 368
Remote i/o system
Hide thumbs
Also See for PACSystems RSTi-EP:
- User manual (539 pages) ,
- Quick start manual (33 pages) ,
- User manual (232 pages)
Table of Contents
Advertisement
User Manual
GFK-2958J
PROFINET Scanner Parameters IO-device Access Point
Figure 229
Inputs Default: Choose whether the RX3i CPU will set inputs from any modules in the
EPXPNS001 module's remote node to Off or Hold Last State in the following cases:
•
•
•
I/O Scan Set: Specifies the I/O scan set to be assigned to the EPXPNS001/ EPXPNS101. Scan
sets are defined in the CPU's Scan Sets tab. The valid range is 1 through 32; the default value
is 1.
PROFINET Scanner Parameters (Media Redundancy Tab)
By default, the EPXPNS001/ EPXPNS101 is not set up for Media Redundancy. If the system
will use Media Redundancy, open the Media Redundancy Tab and select Client.
Figure 230
PROFINET Scanner Parameters (General Parameters Tab)
The EPXPNS001/ EPXPNS101 has below module parameters:
Figure 231
Commissioning
The EPXPNS001/ EPXPNS101 is not operational or is removed.
The EPXPNS001/ EPXPNS101 cannot reach the scanner due to cable or network
configuration issues.
The EPXPNS001/ EPXPNS101 is not able to scan the VersaMax module in its remote
node.
Chapter 8
Oct 2019
353
Advertisement
Table of Contents
