Emerson PACSystems RSTi-EP User Manual page 348

Remote i/o system

Hide thumbs Also See for PACSystems RSTi-EP:

Table of Contents

Figure 210: Sliding the Module into Position

Figure 211: Sliding the End Plate with End Bracket into Position

10. Screw down the end bracket tightly (using a 3-mm screwdriver).

11. Make sure that all release levers are in the locking position as standard. If this is not

Installation

Attach all the other modules as described above.

Connect the second end bracket to the end plate as specified by the alignment pins.

Place both parts on the DIN rail on the right-hand side of the station so that the end

bracket faces outwards.

Slide the end bracket and end plate to the left until it completely connects with the

last module.

the case, click the open release lever into place.