Installation; Preparations For Assembly; Environmental Conditions - Emerson PACSystems RSTi-EP User Manual
Remote i/o system
Hide thumbs
Also See for PACSystems RSTi-EP:
- User manual (539 pages) ,
- Quick start manual (33 pages) ,
- User manual (232 pages)
Table of Contents
Advertisement
User Manual
GFK-2958J
WARNING
Explosion risk - During assembly work, sparks can form and surfaces may become
excessively hot.
•
Before assembly, make sure that there is not a potentially explosive atmosphere.
•
For applications in potentially explosive atmospheres, observe the installation and
construction requirements of EN 60079- 15 and/or country-specific regulations
DANGER
Dangerous contact voltage:
•
Carry out assembly and wiring work on the RSTi-EP station only when the power supply
is disconnected.
•
Make sure that the place of installation (switch cabinet etc.) has been disconnected
from the power supply.
6.1
Preparations for Assembly
The RSTi-EP station is designed for installation in switch cabinets, terminals or switch boxes
in decentralized systems. The field-bus network adapter and I/O modules conform to
protection class IP20.
Environmental Conditions
Make sure that the permitted environmental conditions for installation and operation are
observed (refer to the General Technical Data in Section 1.3, General Technical Data for the
Fieldbus Network Adapter and to Section 0,
Installation
Installation
Chapter 6
Oct 2019
323
Advertisement
Table of Contents
