Emerson PACSystems RSTi-EP User Manual page 411

User Manual
GFK-2958J
5.
6.
7.
Figure 300: Open the Release Lever for the Module to be Removed
8.
9.
10. Slide the module to the left until it audibly clicks into place against the neighboring
11. Return the modules that were slid away back into their original position: slide the
12. Reassemble the end plate and end bracket.
13. Place the plug-in unit in a 90° position from below into the guideway of the base
Replacing Components
Repeat the previous step for all other modules which are located to the right of the
module being replaced: release, slide to the right, and click in once again.
Remove the plug-in unit of the module to be replaced as described in Section 10.1,
Removing/Replacing the Plug-in Unit.
Open the release lever for the module to be removed.
Slide the module to the right and remove it from the DIN rail.
Position the new module with its closed release lever on the DIN rail so that it clicks
audibly into place.
module.
modules to the left so that they audibly click into place on the new module.
Note:
After all the modules have been moved, make sure that they have all been clicked securely
into place on the DIN rail.
module on the new module.
Note
: The plug-in unit can only be inserted in this 90° position.
Chapter 10
Oct 2019
396