B&R Automation Panel 1000 User Manual page 41

4.1.5.1.4 Panel In interface
The interface is designed as a DVI-I connector (female) and can be operated with DVI-D or SDL transmission
technology. For more information, see sections
Video signals SDL and DVI are available for the following link modules: 5DLSDL.1001-00. For details, see the
technical data for the link module or panel used.
Pin Pinout Description
1 TMDS data 2- DVI lane 2 (negative)
2 TMDS data 2+ DVI lane 2 (positive)
3 TMDS data 2/4 SHIELD Shield for data pairs 2 and 4
4
SDL- SDL lane (negative)
5 SDL+ SDL lane (positive)
6 DDC clock DDC-based control signal (clock)
7 DDC data DDC-based control signal (data)
8 Not connected Not connected
9 TMDS data 1- DVI lane 1 (negative)
10 TMDS data 1+ DVI lane 1 (positive)
TMDS data 1/XUSB0
11 Shield of data pair 1 and USB0
SHIELD
12 XUSB0- USB lane 0 (negative)
13 XUSB0+ USB lane 0 (positive)
14 +5 V power +5 V power supply
1)
Ground (return for +5 V,
15 Ground
HSync and VSync)
1) Protected internally by a multifuse.
Information:
Hot plugging output devices on the interface for service purposes is supported by the hardware and
graphic drivers of approved operating systems. Recalibration may be required for touch screen de-
vices.
A maximum of 100 mating cycles are specified for this interface.
Information:
In SDL operation without USB type A/B cable, the USB transfer rate is limited to USB 1.1.
A USB transfer rate of USB 2.0 is possible in DVI or SDL operation with a USB type A/B cable.
4.1.5.1.4.1 USB transfer in SDL and DVI operation
Information:
In SDL operation without USB type A/B cable, the USB transfer rate is limited to USB 1.1.
A USB transfer rate of USB 2.0 is possible in DVI or SDL operation with a USB type A/B cable.
Automation Panel 1000 user's manual V2.00
"SDL operation" on page 17
Pin Pinout
16 HPD
17 TMDS data 0-
18 TMDS data 0+
TMDS data 0/XUSB1
19
SHIELD
20 XUSB1-
21 XUSB1+
22 TMDS clock shield
23 TMDS clock+
24 TMDS clock -
C1 Not connected
C2 Not connected
C3 Not connected
C4 Not connected
C5 Not connected
-
Technical data
and "DVI operation" on page
Description
Hot plug detection
DVI lane 0 (negative)
DVI lane 0 (positive)
Shield of data pair 0 and USB1
USB lane 1 (negative)
USB lane 1 (positive)
Shield of clock pair
DVI clock (positive)
DVI clock (negative)
Not connected
Not connected
Not connected
Not connected
Not connected
-
19.
41