Usb Interface - B&R Automation Panel 1000 User Manual

4.1.6.3 USB interface

AP1000 panels with 10.4", 12.1" (4:3 format only), 15" (4:3 format only) and 19" display diagonals are equipped
with a front USB 2.0 interface. This is equipped with a USB interface cover. IP65 protection (front) is only provided
if the USB interface cover is correctly installed.
The front USB interface is available to the user for service purposes.
Warning!
USB peripheral devices can be connected to the USB interfaces. Due to the variety of USB devices
available on the market, B&R cannot guarantee their functionality. The functionality of USB devices
available from B&R is guaranteed.
Caution!
Due to the general PC specification, this interface must be handled with the utmost care with regard
to EMC, cable routing, etc.
Front USB
The front USB interface is available to the user for service purposes.
Depending on the type of transfer (SDL or DVI operation), there are limitations regarding the transfer rate for
interfaces USB1 and USB2. For possible transfer methods, see section
Transfer method
SDL operation without USB cable
SDL operation with USB cable
Single-touch DVI operation
Multi-touch DVI operation
SDL3 operation
SDL4 operation
1) The max. cable length of 40 m depends on the resolution. For more detailed information, see the table in section
Standard
Variant
Transfer rate
2)
Current-carrying capacity
3)
Cable length
1) The interfaces, etc. available on the device or module have been numbered for the purpose of clear differentiation. This numbering may deviate from the
numbering used by the respective operating system, however.
2) In SDL operation without USB cable (mode 1), the USB transfer rate is limited to USB 1.1.
In SDL3 operation: Low speed (1.5 Mbit/s), full speed (12 Mbit/s) to high speed (30 Mbit/s)
In SDL4 operation: Low speed (1.5 Mbit/s), full speed (12 Mbit/s) to high speed (150 Mbit/s)
3) The USB interface is protected by a maintenance-free "USB current-limiting switch" (max. 500 mA).
Automation Panel 1000 user's manual V2.00
USB type Max. cable length
USB 1.1 40 m
1)
USB 2.0 5 m
USB 2.0 5 m
USB 2.0 5 m
USB 2.0 100 m
USB 2.0 100 m
Front USB
USB 2.0
Type A, female
Low speed (1.5 Mbit/s)
Full speed (12 Mbit/s)
High speed (480 Mbit/s)
Max. 500 mA
Max. 5 m (without hub)
-
"Connection options" on page
Cable lengths and resolutions for SDL
1)
Technical data
17.
transfer.
57