B&R Automation Panel 1000 User Manual page 28

Technical data
AP1000 panels with clamping blocks - Installation diagrams
Figure 4: Automation Panel 1000 with clamping blocks - Installation diagram
The cutout tolerances are +0 mm / -0.5 mm.
Type Model number
10.4" single-touch with keys 5AP1181.1043-000
10.4" single-touch with keys 5AP1182.1043-000
12.1" single-touch 5AP1120.1214-000
15.0" single-touch 5AP1120.1505-000
15.0" single-touch with keys 5AP1180.1505-000
15.0" single-touch with keys 5AP1181.1505-000
19.0" single-touch 5AP1120.1906-000
Dimension "Z" describes the thickness of the wall or control cabinet plate.
A 3 mm hex screwdriver is needed to tighten or remove the screw on the clamping blocks. The maximum tightening
torque of the clamping block is 0.5 Nm.
28
X
Panels
X Y Z min. Z max.
303 341 2 10
403 271 2 10
342 267 2 10
415 313 2 10
415 313 2 10
415 413 2 10
510 404 2 10
Z
Number of clamping blocks
10
8
8
8
8
10
12
Automation Panel 1000 user's manual V2.00