Connecting Cables - B&R Automation Panel 1000 User Manual

Installation and wiring

5.6 Connecting cables

Information:
B&R generally recommends connecting swing arm devices to the Automation PC via SDL4 instead of
SDL. The Cat 6 / Cat 7 cables used with SDL4 are much easier to install and connect.
When connecting or installing cables, the bend radius
specification must be observed. For this specification,
see the technical data of the respective cable.
The maximum tightening torque of the locating screws
is 0.5 Nm.
124
Bend radius
Locating screws
Figure 69: Connecting cables - Bend radius
Automation Panel 1000 user's manual V2.00
Locating screws