Adjusting In Dvi Operation - B&R Automation Panel 1000 User Manual

Commissioning
4. Set the desired brightness using the slider.
Information:
The changed settings are displayed online but only applied by the system (and used after the next
restart) if the Control Center is exited with OK.
The configured brightness is independent of the value configured in BIOS Setup, i.e. the value set
in BIOS is used until Windows boots. The value set in BIOS is only applied the first time the Control
Center is launched.

6.4.2 Adjusting in DVI operation

1. Use the two brightness controls on the SDL/DVI receiver to set the brightness.
128
Figure 70: Adjusting the display brightness
Automation Panel 1000 user's manual V2.00