B&R Automation Panel 1000 User Manual page 116

Installation and wiring
General installation instructions
• Inclined installation reduces the air convection through the device and thus the maximum permissible am-
bient temperature for operation. If there is sufficient external ventilation in an inclined mounting orientation,
the maximum permissible ambient temperature must be checked in each individual case. Failure to do so
may result in damage to the equipment and void the certifications and warranty for the device.
• When installing the device, the permissible mounting orientations must be observed - .
• The device must be installed in such a way that it can be optimally viewed by the user.
• The device must be installed in such a way that reflections on the screen are avoided as far as possible.
• When installed in a closed housing, there must be sufficient volume for air circulation,
• When connecting installed or connected peripherals, follow the instructions in the peripheral device's doc-
umentation.
Information about the gasket
The gasket must be inspected at regular intervals as well as during installation and reinstallation. If any
defects are determined on the gasket during this inspection, it must be replaced and the entire device
inspected. The following points must also be observed:
• Do not stretch the gasket unnecessarily.
• Avoid contact between the gasket and the corners and edges of the frame.
• It is important to ensure that the gasket is completely inserted into the installation notch.
• The housing components must be secured using the specified tightening torque.
Transport and storage
When transporting at low temperatures or in the event of large temperature fluctuations, the collection of moisture
in or on the device is not permitted. Moisture can cause short circuits in electrical circuits and damage the device.
If a device is transported or stored without packaging, all environmental influences such as shocks, vibrations,
pressure and moisture have an unprotected effect on the device. Damaged packaging indicates that the device
has been severely affected by environmental influences and may have been damaged.
This can result in malfunctions of the device, machine or system.
116 Automation Panel 1000 user's manual V2.00