B&R Automation Panel 1000 User Manual page 47

Table of Contents

Advertisement

4.1.5.2.4 SDL3 In interfaces
Information:
For more information, see section
The SDL3 In interface is a female RJ45 connector and operated with SDL3 transmission technology.
The following shows an overview of the video signals possible on the panel input. For
details, see the technical data for the link module or panel used.
Variant
Link module
5DLSD3.1001-00
Information:
Cable lengths and resolutions for SDL3 transfer:
The maximum cable length for SDL3 transfers is 100 m with a B&R SDL3/SDL4 cable (regardless of
the panel resolution).
LED
Color
Status
Link
Yellow
On
Off
Status
Yellow
On
Off
Blinking
Information:
Hot plugging display devices on the SDL3 In interface for service purposes is supported by the hard-
ware and graphics drivers of approved operating systems. The female RJ45 connector is specified for
500 mating cycles.
Information:
If a display device with touch screen is connected to the SDL3 In interface and then disconnected again
during operation (hot plugging), it may be necessary to recalibrate the touch screen.
4.1.5.2.5 USB interfaces
The link module is equipped with a USB 2.0 (Universal Serial Bus) host controller with several USB ports, of which
2 USB interfaces are routed externally and freely available to the user.
Warning!
USB peripheral devices can be connected to the USB interfaces. Due to the variety of USB devices
available on the market, B&R cannot guarantee their functionality. The functionality of USB devices
available from B&R is guaranteed.
Caution!
Due to the general PC specification, this interface must be handled with the utmost care with regard
to EMC, cable routing, etc.
Automation Panel 1000 user's manual V2.00
"SDL3 operation" on page
Description
RJ45 connector, female
Video signals
SDL3
-
Explanation
Indicates an active SDL3 connection.
No active SDL3 connection.
The SDL3 connection is established and OK.
No active SDL3 connection.
Indicates the SDL3 connection is OK, but a
firmware image is corrupt
21.
SDL3 In LEDs
Technical data
Figure
47

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents