Table of Contents
Advertisement
Installation and wiring
5.4 Switch the link module
1. Disconnect the power supply cable to the Automation Panel (disconnect the power cable). Disconnect from
all sources and poles!
2. Carry out electrostatic discharge at the ground connection.
3. Remove the Automation Panel from the control cabinet by following the installation steps in reverse order.
4. Place the Automation Panel on a clean, flat surface.
5. Remove the Torx screws (T10) indicated in the following figure.
6. The link module can now be removed by pulling it straight up.
7. The link module can now be reinstalled by following these steps in reverse order. The max. tightening torque
of the Torx screws (T10) is 0.5 Nm.
120
Figure 65: Removing the Torx screws
Figure 66: Removing the link module
Automation Panel 1000 user's manual V2.00
Advertisement
Table of Contents
Need help?
Do you have a question about the Automation Panel 1000 and is the answer not in the manual?