Installation And Wiring; Basic Information - B&R Automation Panel 1000 User Manual

5 Installation and wiring

5.1 Basic information

A damaged device has unpredictable properties and states. The unintentional installation or startup
of a damaged device must be prevented. The damaged device must be marked as such and made
inaccessible, or it must be returned for repairs immediately.
Unpacking
The following activities must be performed before unpacking the device:
• Check the packaging for visible transport damage.
• If transport damage is noticeable, document this immediately and submit a complaint. If possible, have the
damage confirmed by the carrier/delivery service.
• Check the contents of the shipment for completeness and damage.
• If the contents of the packaging are incomplete, damaged or do not correspond to your order, you must
immediately inform your responsible sales office or B&R Headquarters.
• Keep the original packaging for further transport.
Power supply
The following information is generally applicable and should be observed before performing any work on the device:
• The entire power supply must be disconnected before removing any covers or components from the device
and installing or removing any accessories, hardware or cables.
• Remove the power cable from the device and from the power supply.
• All covers and components, accessories, hardware and cables must be installed or secured before the
device is connected to the power supply and switched on.
Installation
Information:
Optional sets are available that contain all necessary tools for installation. For more information about
tool sets, see section
Before installation
Caution!
If the load-bearing capacity of the mounting surface is insufficient, or if the fastening material
is inadequate or incorrect, the device may fall and become damaged.
The following activities and limitations must be observed before installing the device.
• Allow sufficient space for installation, operation and maintenance of the device.
• The device must be installed on a flat, clean and burr-free surface.
• The wall or control cabinet plate must be able to support four times the total weight of the device. If neces-
sary, bracing must be attached to reinforce the mounting surface.
• To avoid overheating, the device is not permitted to be placed near other heat sources.
Information about the device's environment
• Observe the notes and regulations regarding the power supply and functional ground.
• Observer the specified bend radius when connecting cables.
• Any ventilation holes are not permitted to be covered.
• This device is only approved for use in closed rooms and not permitted to be exposed to direct sunlight.
• The climatic and ambient conditions must be taken into account,
33.
Automation Panel 1000 user's manual V2.00
"General accessories" on page 140.
see "Environmental properties" on page
Installation and wiring
115