Device Interfaces; Sdl/Dvi Receiver (5Dlsdl.1001-00) - B&R Automation Panel 1000 User Manual

4.1.5 Device interfaces

4.1.5.1 SDL/DVI receiver (5DLSDL.1001-00)

4.1.5.1.1 Overview
Information:
For information about SDL/DVI operation, see section
on page 19.
The interfaces available on the device or module are numbered for the purpose of clear differentiation.
This numbering used by the operating system may deviate, however.
No. Interface name
1 Panel In SDL/DVI
2 USB1
3 USB2
4 USB In
5 COM
4.1.5.1.2 +24 VDC power supply
Danger!
The device is only permitted to be supplied with a SELV/PELV power supply or with safety extra-low
voltage (SELV) per EN 60950.
The necessary 3-pin connector is not included in delivery; for suitable accessories, see 0TB103.9x.
The device is protected against overload and reverse polarity by a soldered fuse (15 A, fast-acting). If the fuse
is defective (e.g. due to overload), the device must be sent to B&R for repairs. If the polarity is reversed, it is not
necessary to replace the fuse.
Pin
1
2
3
•
Reverse polarity protection
•
3-pin
• Male
Electrical properties
Nominal voltage
Nominal current
Overvoltage category per EN 61131-2
Galvanic isolation
Uninterruptible power supply
1) EN 60950 requirements must be observed.
Automation Panel 1000 user's manual V2.00
(3)
(2)
(1)
Figure 8: Overview of interfaces - SDL/DVI receiver link module
Chapter
"Panel In interface"
"USB interfaces"
"USB interfaces"
"USB In interface"
"Serial interface"
Description
-
Functional ground
+
"SDL operation" on page 17
(7) (8) (9)
(6)
(5)
(4)
No. Interface name
6 Power 24 VDC
7 Grounding
8 Brightness (DVI) +
9 Brightness (DVI) -
24 VDC ±25%, SELV
1)
Max. 3 A
II
Yes
No
Technical data
or "DVI operation"
Chapter
"+24 VDC power supply"
"Grounding"
"Brightness controls"
"Brightness controls"
Figure
1 2 3
39