10.4" Devices - B&R Automation Panel 1000 User Manual

A.5.2.3 10.4" devices
The cutout tolerance for the PP100/200, PP300/400, PP500, AP900, PPC700 and PPC800 is ±0.5 mm.
The cutout tolerance for the AP1000 is +0 mm / -0.5 mm.
PP100/200/300/400
PP100/200/300/400
10.4" Automation Panel 1000, Automation Panel 900, Panel PC 700, Power Panel 500, Power Panel 300/400 and
Power Panel 100/200 devices in Landscape1 format are 100% compatible.
10
PP100/200/300/400
PP500
10.4" Automation Panel 1000, Automation Panel 900, Panel PC 700 and Power Panel 500 devices are not 100%
compatible with Power Panel 300/400 or Power Panel 100/200 devices in Landscape2 format. Automation Panel
1000, Automation Panel 900, Panel PC 700 and Power Panel 500 devices need a cutout that is 4.5 mm larger
(bottom edge) and 0.5 mm wider (left and right).
The larger cutout can be used conditionally for all devices:
• During installation, it is important to ensure that the PP100/200 and PP300/400 devices are positioned and
installed as centrally as possible in the cutout. If this is not the case, the retaining clips can no longer grip
and impermeability is no longer ensured by the circumferential cord gasket (IP65).
Automation Panel 1000 user's manual V2.00
10
PP500
PP500
Outer contour of device
Cutout for device
Figure 106: Installation compatibility - 10.4" devices - Landscape1
Outer contour of device
Cutout for PP100/200/300/400 device
Cutout for AP900/PPC700 device
Cutout for PP500/AP1000 device
Figure 107: Installation compatibility - 10.4" devices - Landscape2
323 x 260 10
8.5
303 x 243
423 x 288
402 x 266.5
402 x 271
403 x 271
AP900/PPC700 AP1000
AP900 AP1000
8.5
10
8.5
AP900/PPC700
AP1000
13 PP100/200/300/400
8.5 AP900, PPC700
8.5 PP500, AP1000
0.5
Appendix A
197