Dimensions; Drilling Template; Connecting To The End Device - B&R Automation Panel 1000 User Manual

Accessories
Model number

Dimensions

Width
Length
Depth
Weight
1) Yes, but applies only if all components installed in the complete system have this certification and the complete system bears the corresponding mark.
2) Yes, but applies only if all components installed in the complete system have this certification and are listed on the associated DNV GL certificate for the
product family.
3) EN 60950 requirements must be observed; see section "+24 VDC power supply" of the user's manual.
9.5.1.4 Dimensions
35°

9.5.1.5 Drilling template

9.5.1.6 Connecting to the end device

The line filter must be connected between the power supply and the end device.
The following points must be observed:
• Use shielded, twisted wires.
• Keep the lines as short as possible (power supply - line filter - end device).
• The line filter must be installed on an uncoated, oil-free metallic surface.
170
Table 73: 5AC804.MFLT-00 - Technical data
14.3
94
Figure 96: 5AC804.MFLT-00 - Dimensions
ø 5.4
4x
47
45
ø 3.5
2x
9
7
0
Figure 97: 5AC804.MFLT-00 - Drilling template
Line filter
Figure 98: Connection example
5AC804.MFLT-00
54 mm
94 mm
32.15 mm
205 g
1
54
End device
Automation Panel 1000 user's manual V2.00