B&R Automation Panel 1000 User Manual page 141

Model number
General information
Certifications
CE
EAC
UL
HazLoc
DNV GL
Terminal block
Note
Number of pins
Type of terminal block
Cable type
Spacing
Connection cross section
AWG wire
Wire end sleeves with plastic covering
Solid wires
Fine-stranded wires
With wire end sleeves
Tightening torque
Electrical properties
Nominal voltage
Nominal current
4)
Contact resistance
Operating conditions
Pollution degree per EN 61131-2
1) Yes, but applies only if all components installed in the complete system have this certification and the complete system bears the corresponding mark.
2) Yes, but applies only if all components installed in the complete system have this certification and are listed on the associated DNV GL certificate for the
product family.
3) The cage clamp terminal block cannot be used side by side.
4) The respective limit data of the I/O modules must be taken into account!
Automation Panel 1000 user's manual V2.00
0TB103.9
Screw clamp terminal block variant
26 to 14 AWG
0.20 to 1.50 mm²
0.4 Nm
Table 51: 0TB103.9, 0TB103.91 - Technical data
Yes
Yes
cULus E115267
Industrial control equipment
cULus HazLoc E180196
Industrial control equipment
for hazardous locations
Class I, Division 2, Groups ABCD, T4
Temperature: B (0 - 55°C)
Humidity: B (up to 100%)
Vibration: A (0.7 g)
EMC: B (bridge and open deck)
Protected against vibration by the screw flange
Nominal data per UL
3 (female)
Cage clamp terminal block variant
Only copper wires (no aluminum wires!)
5.08 mm
0.20 to 1.50 mm²
0.20 to 2.50 mm²
0.20 to 1.50 mm²
300 V
10 A / contact
≤5 mΩ
Pollution degree 2
Accessories
0TB103.91
1)
2)
3)
26 to 12 AWG
0.20 to 2.50 mm²
-
141