Adaptec AAR-21610SA Reference Manual page 164

Syntax
controller set automatic_failover
[/failover_enabled{=boolean}]
/failover_enabled{=boolean}
Specifies whether to turn on or off automatic failover on the
specified controller. You must set this switch to TRUE if you
want to turn on automatic failover on the specified controller.
To turn off automatic failover on the specified controller, set
this switch to FALSE. The command defaults to TRUE, which
means the command turns on automatic failover on the
specified controller.
Examples
Before turning the automatic failover feature on or off, check its
status by using the controller show automatic_failover
command.
The following example shows that the controller's automatic
failover is currently disabled:
AAC0> controller show automatic_failover
Executing: controller show automatic_failover
Automatic failover DISABLED
The following example turns on (enables) the automatic failover
feature for the currently opened controller:
AAC0> controller set automatic_failover /failover_enabled
Executing: controller set automatic_failover /failover_enabled=TRUE
The controller show automatic_failover command
indicates that the controller's automatic failover is currently
enabled:
AAC0> controller show automatic_failover
Executing: controller show automatic_failover
Automatic failover ENABLED
Related Commands
array commands:
I
array set failover
I
array set global_failover
controller commands:
I
controller show automatic_failover
(page 3-95)
(page
controller Commands
3-97)
(page
4-21)
4-18