Enclosure Set Power - Adaptec AAR-21610SA Reference Manual

enclosure set power

To turn the power of a specific power supply on a specific SAF-TE
enclosure management device on or off, use the enclosure set
power command. Typically, most enclosure management devices
turn on their associated power supplies by default after power up.
Syntax
enclosure set power [/off{=boolean}] {enclosure}
{powersupply}
Parameters
{enclosure}
Specifies the ID associated with the enclosure management
device on which you want to turn the power of a specific
power supply on or off. For this version, the controller
supports a maximum of eight enclosure management devices
on each bus.
{powersupply}
Specifies the unit number associated with the power supply
whose power you want to turn on or off. The unit number for
the power supply can range from 0 to 15 inclusive.
Switches
/off{=boolean}
Specifies whether to turn the power supply associated with
the specified unit number on or off. If you set this switch to
TRUE, the command turns off the power supply associated
with the specified unit number. If you specify FALSE, the
command turns on the power supply associated with the
specified unit number.
This switch defaults to FALSE, which means the command
turns on the power supply if you do not specify the switch.
enclosure Commands
9-19