Table of Contents
Advertisement
The following example creates a mirror set asynchronously and
sets an I/O delay of 20 milliseconds for array 0. You need to
perform the create mirror task asynchronously. Otherwise, you
cannot change the I/O delay:
container create mirror /io_delay=20 0 (0,2,0)
Executing container create mirror /io_delay=20 0 (CHANNEL=0,ID=2,LUN=0)
The following example shows how to change the I/O delay to 40
milliseconds on the currently running create mirror task:
AAC0>container set io_delay 0 40
Executing: container set io_delay 0 40
Use the
container list
set io_delay command to display information about the array,
as in the following example:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0
Volume 10.0MB
As the example shows, there is no difference between the array list
display prior to and after the set I/O delay operation.
Related Commands
container commands:
I
container create mirror
I
container create mmirror
I
container list
I
container scrub
command after using the container
Total
Oth Stripe
Size
Ctr Size
(page
(page
Scsi
Usage
C:ID:L Offset:Size
NTFS
0:02:0 64.0KB:
(page
3-5)
(page
3-8)
3-50)
3-88)
container Commands
Partition
10.0MB
3-100
Advertisement
Table of Contents
