Container Create Stripe - Adaptec AAR-21610SA Reference Manual

container create stripe

To create a stripe set from freespace, use the container create
stripe command.
Notes
If you created a stripe set you can run the list devices
command on the NetWare console to verify its creation and then
create the necessary NetWare disk partitions and volumes.
For information on how to create partitions and volumes, see the
appropriate NetWare documentation.
Syntax
container create stripe [/cache{=boolean}]
[/stripe_size{=integer}] [/label{=string}]
{free_space} [{scsi_device}...]
Parameters
{free_space}
Specifies the SCSI device and its associated freespace used to
create the stripe set.
For further details, see
{scsi_device}...
Specifies one or more SCSI devices. A SCSI ID consists of a
SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0
through 15 inclusive), and SCSI device logical unit number (0
through 7 inclusive). See the installation guide for your
controller to determine the number of buses it actually
supports.
For further details, see
The command uses the freespace(s) from the SCSI device(s) to
create the stripe set. The size from the device is identical to
the one you specify in the free_space parameter.
The minimum number of partitions for a stripe set is 2, and
the maximum number is 16.
free_space on page
scsi_device on page
container Commands
1-11.
1-10.
3-27