Table of Contents
Advertisement
container create mmirror
To create a multilevel array of mirror sets from a multilevel array of
single-partition volume sets and freespace, use the container
create mmirror command. Typically, you use this command
after promoting a volume set built from multiple partitions with
the container promote command.
The container create mmirror command is fully dynamic. If
you use this command, users will not see any change or experience
any interruption in service. However, performance may be
reduced.
Notes
When creating a multilevel array of mirror sets on a NetWare
server, you specify the container IDs (as described in the
Parameters section) for the arrays from which you want to create
the multilevel mirror set. If NetWare is using any of these arrays, an
appropriate message displays. This message indicates that one or
more of the arrays you specified is in use by NetWare. The message
directs you to remove any NetWare volumes and partitions from
these arrays. You can then create a multilevel array of mirror sets
on a NetWare server.
After you create a multilevel array of mirror sets you can run the
list devices command on the NetWare console to verify its
creation and then create the necessary NetWare disk partitions and
volumes.
For information on how to create partitions and volumes, see the
appropriate NetWare documentation.
Syntax
container create mmirror [/io_delay{=integer}] [/
wait{=boolean}] {container} {scsi_device}
[{scsi_device}...]
Parameters
{container}
Specifies the ID number (0 to 63) of the array whose
underlying volume sets the command converts to mirror sets.
You create a multilevel array of mirror sets from a multilevel
array of single-partition volume sets and freespace.
container Commands
3-8
Advertisement
Table of Contents
