Table of Contents
Advertisement
I
Stripe, chunk—Contiguous set of data distributed across all the
disks in an array. A striped array distributes data evenly across
all members in equal-sized sections called stripes.
I
Free or available space—Space on an initialized disk that is not
in use.
I
Partition—Contiguous area of a physical drive that makes up
some or all of an array.
I
Hotspare, failover disk—A hard drive, an array member, that is
not used in day-to-day data storage, but is instead reserved for
use as a replacement for one of the other drives in the array in
the event of a failure.
Conventions
This section discusses conventions important to the interface.
I
Case sensitivity—CLI syntax elements are not case-sensitive
except for strings.
I
Command abbreviations—You can abbreviate commands,
subcommands, and switches. You must provide enough
characters so the commands are not ambiguous.
I
Subcommand Mode—Subcommand mode simplifies
command entry when you are performing repetitive commands
on the same item. Subcommand mode works only for
commands that have one or more subcommands.
To enter subcommand mode, type the first part of any command
that has subcommands and press Enter. The command you entered
replaces the CLI> prompt and becomes the first part of any
subsequent command you enter.
For example, to use subcommand mode for the array command:
1 Type array at the CLI> prompt, and press Enter.
The CLI> prompt changes to _array >.
2 Enter valid subcommands, switches, and parameters for any
array command and press Enter. For example, to change the
number of array 1 to 2, simply type the following at the _array
> prompt and press Enter:
move 1 2
Introduction
1-4
Advertisement
Table of Contents
