Adaptec AAR-21610SA Reference Manual page 61

Use the container list command after using the container
create stripe command to display information about the
array, as in the following example:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Stripe 45.0MB
The following list describes the items in the display that contain
information as the result of creating a array with the container
create stripe command:
I
The Num Label column displays the ID number of the newly
created array, which in the example is 0.
If you specify a label when creating the array, it appears in
this column. Because no label was specified when the array
was created, no label appears in the column.
On UNIX systems, the root special file associated with the
array also appears in this column.
I
The Type column displays the type Stripe, to indicate that
the newly created array is a array.
I The Total Size column displays the size of the freespace that
makes up the array. In this example, the total size consists of
the freespace (15.0 MB) specified with SCSI device (0,2,0) and
equal sizes associated with SCSI devices (0,3,0), and (0,4,0) for
a total of 45.0 MB.
I
The Stripe Size column displays the stripe size you specified
for the array. In this example, the stripe size is the default
(32 KB).
I
The Usage column displays None to indicate that the newly
created array does not have a file system on it. To create an
NTFS or FAT file system on an array, use the container
format command.
I The Scsi C:ID:L column displays the SCSI device ID(s) for the
disk(s) whose associated freespaces you used to create the
array. In this example, the display shows 0:02:0, 0:03:0, and
0:04:0.
Total Oth Stripe
Size Ctr Size
64KB
Scsi
Usage C:ID:L Offset:Size
None 0:02:0 64.0KB:
0:03:0 64.0KB:
0:04:0 64.0KB:
container Commands
Partition
15.0MB
15.0MB
15.0MB
3-30