Table of Contents
Advertisement
Examples
Before extending a multilevel volume set, use the container
list command to obtain information about any existing arrays.
As the following example shows, there is an array 0 (a multilevel
volume set) on this controller. In addition, the example shows array
1 and array 2 (both volume sets created with the container
create volume command).
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0
Volume 10MB
63
Volume 10MB
1
Volume 15MB
2
Volume 15MB
The following example extends a multilevel volume set (array 0) by
adding arrays 1 and 2 (which are both volume sets):
AAC0>container extend mvolume 0 1 2
Executing: container extend mvolume 0 1 2
container 0 extended
As the command executes, note that the title bar of the DOS
window displays the status of the command. For example:
Stat:OK!Task:102,Func:FSX Ctr:0,State:RUN 84.3%
For further details on status information, see
Use the container list command after using the container
extend mvolume command to display information about the
multilevel array of volume sets after you extend it, as in the
following example:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
F:
0
Volume 40MB
63
Volume 10MB
62
Volume 15MB
61
Volume 15MB
Total
Oth Stripe
Size
Ctr Size
Total
Oth Stripe
Size
Ctr Size
Scsi
Usage
C:ID:L Offset:Size
NTFS
0:02:0 64.0KB:
None
0:03:0 64.0KB:
None
0:04:0 64.0KB:
page
Scsi
Usage
C:ID:L Offset:Size
NTFS
0:02:0 64.0KB:
0:03:0 64.0KB:
0:04:0 64.0KB:
container Commands
Partition
10.0MB
15.0MB
15.0MB
1-13.
Partition
10.0MB
15.0MB
15.0MB
3-44
Advertisement
Table of Contents
