Table of Contents
Advertisement
enclosure prepare slot
To indicate to the SAF-TE enclosure management device that it
should take the appropriate action to prepare the device in a
specific slot for removal or insertion, use the enclosure
prepare slot command.
This command may perform such operations as shutting off power
to the device slot. This allows users to safely remove a disk device
from or insert a disk device into the device slot.
Syntax
enclosure prepare slot {enclosure} {slot}
Parameters
{enclosure}
Specifies the ID associated with the enclosure management
device on which you want to prepare a slot. For this version,
the controller supports a maximum of eight enclosure
management devices on each bus.
{slot}
Specifies the unit number associated with the slot. This is the
slot that contains the device you want to prepare to make
available. This unit number can range from 0 to 15 inclusive.
Examples
Before preparing a device in the slot, you might want to use the
enclosure show slot command to determine the current
device slot status:
AAC0>enclosure show slot
Executing: enclosure show slot
Enclosure Slot scsiId Insert
--------- ---- ------ ------- ----------------------------------------
0
0
0:00:0
0
1
0:01:0
0
2
0:10:0
0
3
0:03:0
0
4
0:04:0
1
0
1:00:0
1
1
1:01:0
1
2
1:10:0
1
3
1:03:0
1
4
1:04:0
Status
4
OK UNCONFIG ACTIVATE
0
OK UNCONFIG ACTIVATE
0
OK UNCONFIG ACTIVATE
0
OK UNCONFIG ACTIVATE
0
OK UNCONFIG ACTIVATE
0
OK CONFIG
0
OK UNCONFIG ACTIVATE
0
OK UNCONFIG ACTIVATE
0
OK UNCONFIG ACTIVATE
0
OK UNCONFIG ACTIVATE
enclosure Commands
ACTIVATE
9-11
Advertisement
Table of Contents
