Table of Contents
Advertisement
Use the container show failover command after removing a
failover disk from an array's failover disk list with the container
remove failover command to display information about the
array's failover disk list, as in the following example:
AAC0>container show failover
Executing: container show failover
container Scsi C:ID:L
--------- ----------------------------------
GLOBAL
1:03:0
0
--- No Devices Assigned ---
As the display shows, SCSI device (1,2,0) is no longer in the failover
disk list for all arrays. However, SCSI device (1,3,0) remains in the
failover disk list for all arrays.
Related Commands
container commands:
I
container set failover
I
container set global_failover
I
container show failover
container Commands
(page
3-95)
(page
(page
3-108)
3-97)
3-85
Advertisement
Table of Contents
