Container Restore Raid5 - Adaptec AAR-21610SA Reference Manual

container restore RAID5

To restore a RAID 5 array, use the container restore RAID5
command. Typically, you use this command to restore a RAID 5
array that contains one or more dead partitions. This command
does not always succeed; therefore, use it only if all other measures
fail.
One situation where the command might prove useful is for those
situations where you may have inadvertently pulled a drive and
then almost immediately put it back. The act of pulling the drive
may cause some dead partitions to appear. You can then restore the
RAID 5 array using this command.
Syntax
container restore RAID5 {container}
Parameters
{container}
Specifies the ID number (0 to 63) of the array (a RAID 5 array)
to restore.
Examples
Before restoring a RAID 5 array, use the container list
command to display information about the RAID 5 array. If a
partition is dead, the ":" (colon) in the Partition Offset:Size
column changes to a "!" (exclamation point).
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
0 RAID-5 30.0MB
The previous example shows that there is one dead partition on
this RAID 5 array. The following example uses the container
restore RAID5 command to attempt to restore the RAID 5 array:
AAC0>container restore RAID5 0
Executing: container restore RAID5 0
Total Oth Stripe
Size Ctr Size
64KB
Scsi
Usage C:ID:L Offset:Size
None 0:02:0 64.0KB!
0:03:0 64.0KB:
0:04:0 64.0KB:
0:05:0 64.0KB:
container Commands
Partition
10.0MB
10.0MB
10.0MB
10.0MB
3-86