Table of Contents
Advertisement
Use the container list command after the container
create mirror command completes execution to display
information about the mirror set, as in the following example:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
0
Mirror 10MB
The following list describes the changes to the display as a result of
using the container create mirror command:
I
The Type column displays a new array type, which in the
example is Mirror instead of the previously displayed
Volume.
I
The State column displays Normal (instead of a blank) as the
mirror state.
(Note that this column appears only if you specify the /full
switch with the container list command.)
I
The Scsi C: ID: L column displays the SCSI device IDs for the
two halves of the mirror set.
I
The Partition Offset:Size column displays the partition offset
and size for the two halves of the mirror set.
If a partition is dead, the ":" (colon) in the Partition
Offset:Size column changes to a "!" (exclamation point). See
the disk remove dead_partitions
command for more information on dead partitions.
After creating a mirror set, you can manipulate it by using the
I
container split command to split a mirror set
I
container unmirror command to unmirror a mirror set
Related Commands
container commands:
I
container create mmirror
I
container list
I
container split
I
container unmirror
disk commands:
I
disk remove dead_partitions
Total
Oth Stripe
Size
Ctr Size
(page
(page
Scsi
Usage
C:ID:L Offset:Size
NTFS
0:02:0 64.0KB:
0:03:0 64.0KB:
(page
3-8)
3-50)
3-109)
(page
3-114)
(page
container Commands
Partition
10.0MB
10.0MB
(page
5-10)
5-10)
3-7
Advertisement
Table of Contents
