Adaptec AAR-21610SA Reference Manual page 102

I
Move partitions to other disks
You can move an array's partitions to other disks by
specifying the appropriate switches with a valid partition or
partitions. For example, you can move three entries of a
RAID 5 array to new disks.
You can combine the previously listed operations.
Notes
Some reconfigure operations result in destination sizes slightly
different than what you specified.
When you perform an array reconfigure operation on a UNIX
operating system you may see a resource conflict-related error.
Typically, this error occurs when there is not enough space on the
disk to perform the reconfigure operation. To correct the problem,
use another disk (with more space) to perform the reconfigure
operation.
Syntax
container reconfigure [/stripe_size{=integer}]
[/extend_fs{=boolean}][/mirror{=boolean}]
[/partition_move{=boolean}]
[/partition_size{=integer}] [/raid5{=boolean}]
[/raid10{=boolean}][/volume{=boolean}]
[/wait{=boolean}] {container} [{scsi_device}...]
Parameters
{container}
Specifies the ID number (0 to 63) of the array you want to
reconfigure.
container Commands
3-71