Adaptec AAR-21610SA Reference Manual page 87

Task Meaning
A rebuild task is running on the specified array. Typically, the
Rebuild
rebuild task runs when the controller is in a rebuild for a
redundant array (RAID 5 array, mirror set, or multilevel array
of mirror sets).
An array reconfigure task is running on the specified array.
Reconfg
When the array reconfigure task completes, the specified
array becomes a different array (for example, from a volume
set to a stripe set). The array reconfigure task runs as a result
of using the
A scrub task is running on the specified redundant array.
Scrub
When the scrub task completes, the specified redundant array
has reconstructed data on one partition based on data found
on the other partition (for mirror sets and multilevel arrays of
mirror sets). Or, the specified redundant array recalculates
and replaces, if necessary, the parity information (for RAID 5
arrays). The scrub task runs as a result of the
scrub
container create raid5
scrub
A verify with no repair of bad blocks task is running on the
Verify
specified SCSI disk. When the verify with no repair of bad
blocks task completes, the specified SCSI disk's blocks were
verified without repairing any detected defects. The verify
with no repair of bad blocks task runs as a result of using the
disk verify
repair
A verify with repair of bad blocks task is running on the
VfyRepl
specified SCSI disk. When the verify with repair of bad blocks
task completes, the specified SCSI disk's blocks are verified
with repairs. The verify with repair of bad blocks task runs as
a result of using the
repair
A clear disk task is running on the specified SCSI disk. When
Zero
the clear disk task completes, the specified SCSI disk is
cleared (that is, all data is erased and cannot be recovered).
The clear disk task runs as a result of using the
command.
Table 3-4 Task Types (Continued)
container reconfigure
command. The scrub task also runs as a result of the
switch specified.
command without specifying the
switch.
disk verify
switch.
container Commands
command.
container
command with the
/
command with the
disk zero
/
/
3-56