Table of Contents
Advertisement
Parameters
{container}
Specifies the ID number (0 to 63) of the array whose file
system you want to extend.
Examples
Typically, you would use the container extend file_system
command after adding a level to an array and, perhaps, after
extending a multilevel volume set.
Before extending a file system, use the container list
command to obtain information about any existing arrays:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
E: 0
Volume 300MB
63
Volume 100MB
62
Volume 100MB
61
Volume 100MB
The following list describes the sequence that caused the previous
example to display:
Create a volume set of 100 MB on disk (1,0,0) with the
1
container create volume command.
2
Add a level to the volume set created in
container add_level command.
3
Assign a drive letter to the volume set created in
the container assign drive_letter command.
Create an NTFS file system on the volume set created in Step
4
1 with the container format command.
5
Create a second volume set of 100 MB on disk (1,1,0) with the
container create volume command.
Create a third volume set of 100 MB on disk (1,2,0) with the
6
container create volume command.
7
Use the container extend mvolume command to add the
arrays created in Steps
Total
Oth Stripe
Size
Ctr Size
5
and
Scsi
Usage
C:ID:L Offset:Size
NTFS
1:00:0 64.0KB:
1:01:0 64.0KB:
1:02:0 64.0KB:
Step 1
6
to the array created in
container Commands
Partition
100MB
100MB
100MB
with the
Step 1
with
Step
1.
3-41
Advertisement
Table of Contents
