Table of Contents
Advertisement
/extend_fs{=boolean}
Specifies whether to extend the file system so that it occupies
the entire reconfigured array. If you specify TRUE, the
command adds no new freespace and extends the file system
so that it occupies the entire reconfigured array. (The
command extends the file system after completing the
reconfigure operation.) If you specify FALSE, the command
adds freespace to the reconfigured array and does not extend
the file system to occupy the entire reconfigured array.
This switch defaults to FALSE.
This switch applies only to those multilevel volume sets on
which an NTFS file system resides. If you extend an NTFS file
system, you must reboot your system in order for the
extension to take effect.
If you do not specify this switch, you can later extend the file
system with the container extend file_system
command.
This switch is supported on Windows.
/mirror{=boolean}
Specifies whether to reconfigure the existing array into a
mirror set. If you specify TRUE, the command reconfigures
the existing array into a mirror set. If you specify FALSE, the
command does not reconfigure the existing array into a
mirror set.
This switch defaults to FALSE.
/partition_move{=boolean}
Specifies whether to move partitions instead of adding extra
space (using additional disks). If you specify TRUE, the
command moves partitions instead of adding extra space. If
you specify FALSE, the command does not move partitions.
This switch defaults to FALSE.
/partition_size{=integer}
Specifies the partition size. All partitions must be the same
size and you can specify only one partition per disk.
container Commands
3-73
Advertisement
Table of Contents
