Table of Contents
Advertisement
enclosure show power
To display the status of a specific power supply on a specific SAF-
TE enclosure management device, use the enclosure show
power command. You can also use this command to display the
status of all power supplies on the enclosure management device
or devices.
Syntax
enclosure show power [{enclosure}]
[{powersupply}]
Parameters
{enclosure}
Specifies the ID associated with the enclosure management
device for which you want to display power supply status
information. For this version, the controller supports a
maximum of eight enclosure management devices on each
bus.
If you do not specify an ID, the command displays the power
supply status for all enclosure management devices
connected to the controller.
{powersupply}
Specifies the unit number associated with the power supply
whose status you want to display. This integer can range from
0 to 15 inclusive.
If you do not specify a unit number, the command displays
the status for all power supplies on the enclosure
management device or devices.
Examples
The following example displays the status of the power supplies on
enclosure management devices 0 and 1:
AAC0>enclosure show power
Executing: enclosure show power
Enclosure Power State
--------- ----- ------------ -------
0
0
1
0
Status
OK
ON
OK
OFF
enclosure Commands
9-29
Advertisement
Table of Contents
