Table of Contents
Advertisement
Examples
Before assigning a label to a specific array, use the container
list command to obtain information about any existing arrays.
As the following example shows, there is an array 0 (a volume set)
on this controller with no label assigned to it (as evidenced by no
label in the Num Label column):
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
0
Volume 15.0MB
The following example assigns the label Tigris to array 0:
AAC0>container set label 0 Tigris
Executing: container set label 0 "Tigris"
Use the container list command after using the container
set label command to display the new label, as in the following
example:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
0
Volume 15.0MB
Tigris
As the example shows, the new label Tigris now appears in the
Num Label column.
Related Commands
container commands:
I
container create mstripe
I
container create mvolume
I
container create raid5
I
container create stripe
I
container create volume
I
container format
Total
Oth Stripe
Size
Ctr Size
Total
Oth Stripe
Size
Ctr Size
(page
Scsi
Usage
C:ID:L Offset:Size
None
0:02:0 64.0KB:
Scsi
Usage
C:ID:L Offset:Size
None
0:02:0 64.0KB:
(page
3-12)
(page
3-17)
(page
3-21)
(page
3-27)
(page
3-32)
3-50)
container Commands
Partition
15.0MB
Partition
15.0MB
3-102
Advertisement
Table of Contents
