Table of Contents
Advertisement
Examples
Use the container list command to obtain information about
any existing arrays. As the following example shows, there is an
array 0 (a mirror set) and an array 1 (a volume set) on this
controller:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
0
Mirror 15.0MB
Tigris
E: 1
Volume 15.0MB
The following example reconfigures a volume set to a stripe set:
AAC0>container reconfigure /partition_size=1 /stripe 1
Executing: container reconfigure /partition_size=1
As the command executes, note that the title bar of the DOS
window displays the status of the command. For example:
Stat:OK!Task:100,Func:RCF Ctr:1,State:RUN 97.2%
For further details on status information, see
Use the
container list
command to display information about the array
reconfigure
you just reconfigured, as in the following example:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
0
Mirror 15.0MB
Tigris
E: 1
Stripe 15.0MB
As the result of reconfiguring an array (in this example, array 1)
with the container reconfigure command, the Type column
displays Stripe (instead of Volume) to indicate that the specified
array is now a stripe set instead of a volume set.
Related Commands
container commands:
I
container create mirror
I
container create raid5
I
container create stripe
I
container create volume
Total
Oth Stripe
Size
Ctr Size
command after using the
Total
Oth Stripe
Size
Ctr Size
Scsi
Usage
C:ID:L Offset:Size
None
1:02:0 64.0KB:
1:03:0 64.0KB:
NTFS
1:00:0 64.0KB:
page
Scsi
Usage
C:ID:L Offset:Size
None
1:02:0 64.0KB:
1:03:0 64.0KB:
NTFS
1:00:0 64.0KB:
(page
3-5)
(page
3-21)
(page
3-27)
(page
3-32)
container Commands
Partition
15.0MB
15.0MB
15.0MB
/stripe=TRUE 1
1-13.
container
Partition
15.0MB
15.0MB
15.0MB
3-75
Advertisement
Table of Contents
