Table of Contents
Advertisement
container remove global_failover
To remove one or more failover disks that were assigned to all
arrays through the container set global_failover
command, use the container remove global_failover
command.
Syntax
container remove global_failover {scsi_device}
[{scsi_device}...]
Parameters
{scsi_device}
Specifies the ID for the SCSI device that you want to remove
as a failover disk for all arrays. You previously assigned this
SCSI device as a failover disk with the
global_failover
For further details, see
{scsi_device}...
Specifies the ID(s) for any other SCSI device(s) you want to
remove as failover disk(s) for all arrays. You previously
assigned these SCSI device(s) as failover disk(s) with the
container set global_failover command.
Examples
Before removing one or more failover disks from all arrays, use the
container show failover command to obtain information
about any existing failover disks assigned to arrays.
As the following example shows, there is an array 0 that has SCSI
devices (1,2,0) and (1,3,0) assigned to it.
AAC0>container show failover
Executing: container show failover
container Scsi C:ID:L
--------- ----------------------------------
GLOBAL
1:02:0
0
--- No Devices Assigned ---
The following example removes SCSI device 1:02:0 as an assigned
failover disk for all arrays:
AAC0>container remove global_failover (1,2,0)
Executing: container remove global_failover (CHANNEL=1,ID=2,LUN=0)
command.
scsi_device on page
1:03:0
container Commands
container set
1-10.
3-84
Advertisement
Table of Contents
