Container Lock - Adaptec AAR-21610SA Reference Manual

container lock

!
Caution: Use the container lock command only under
the direction of technical support.
To lock an array into volatile memory space on the currently
opened controller, use the container lock command. When an
array is locked into volatile memory space, the container
reconfigure command has no effect. A locked array cannot be
moved, deleted, made read-only, or used to create a multilevel
array.
Syntax
container lock {container}
Parameters
{container}
Specifies the ID number (0 to 63) of the array to lock into
volatile memory space.
Examples
Before locking an array, use the container list command
(with the /full switch) to obtain information about any existing
arrays. As the following example shows, there is an array 0 (a
volume set) on this controller. Note that the Lk column is blank:
AAC0>container list /full
Executing: container list /full=TRUE
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- --------
F: 0 Volume 10.0MB
Note that the example eliminates some items in the container
list display so that you can see an example of the Lk column.
The following example locks array 0 into volatile memory space:
AAC0>container lock 0
Executing: container lock 0
Total Oth Stripe
Size Ctr Size
Scsi
Usage C:ID:L
NTFS 0:02:0
container Commands
Lk
--
3-59