Table of Contents
Advertisement
Accessing CLI in NetWare
To access the CLI from the NetWare server console, type aaccli at
the prompt. When the system displays the CLI> prompt, which
indicates that you can now use CLI commands.
Terminology
This section discusses terminology used in this Appendix.
Adaptec 2410SA/2810SA Controllers Only
In the device ID format C:ID:L:
I
C represents Channel, which is always zero.
I
ID represents Port ID, or Port number, on the SATA RAID
controller. This is the only value that is used.
I
L represents LUN, which is always zero.
Note:
Only the value for Port ID is used.
Adaptec 21610SA Controllers Only
In the device ID format C:ID:L:
I
C represents Channel.
I
ID represents Port ID. (For mapping, see below.)
I
L represents LUN, which is always zero.
Your Serial ATA adapter maps Port IDs as follows:
I
Controller ports 0 through 7 are mapped to IDs 0 through 7 on
Channel 0
I
Controller ports 8 through 15 are mapped to IDs 0 through 7 on
Channel 1
For example, port 5 is 0:5:0; port 12 is 1:4:0.
All Controllers
The following terms are used in discussing the CLI:
I
Array, container—A logical disk created from available space
and made up of one or more partitions on one or more physical
disks.
Introduction
1-3
Advertisement
Table of Contents
