Table of Contents
Advertisement
I
The Usage column displays None to indicate that the newly
created RAID 5 array does not have a file system on it.To
create an NTFS or FAT file system on an array, use the
container format command.
I
The State column displays the state of an array, which in the
example shows Unprot to indicate that the RAID 5 array is
not yet redundant. This means that the command has not
completed the creation of the RAID 5 array. If the
command is executed after the RAID 5 array completes
list
execution, the State column is blank.
(Note that this column appears only if you specify the /full
switch with the container list command.)
I
The Scsi C:ID:L column displays the SCSI device ID(s) for the
disk(s) on which you created the RAID 5 array, which in the
example are: 0:02:0, 0:03:0, 0:04:0, and 0:05:0.
I
The Partition Offset: Size column displays the partition
offset(s) and size(s) of the newly created RAID 5 array, which
in the example is 64.0 KB and 10.0 MB respectively.
Related Commands
commands:
container
I
container list
I
container set cache
I
container set label
(page
3-50)
(page
3-91)
(page
3-101)
container Commands
container
3-26
Advertisement
Table of Contents
