Defining Ready Delay - Nordson ProBlue Flex User Manual

SETUP TOOL
Please select how to load a configuration file
LOAD FROM USB/COMPUTER
USE PREVIOUS FILE
CREATE NEW
SYSTEM SETTINGS
TEMPERATURE
E 2020 Nordson Corporation

Defining Ready Delay

Use Ready Delay to prevent the melter from immediately exiting out of
Heating when the tank reaches its set point temperature, thereby allowing
enough time for adhesive to melt that is sufficient for production.
NOTE:
S
Regardless of a cold start, if Ready Delay is enabled, the melter will enter
Ready Delay if the manifold set point is less than 28_ C (50_ F) of its set
point. Enabling other external zones has no effect on Ready Delay.
1. Log into your BBconn Cloud account, then do the following:
S
Select SETUP TOOL - create or load a .NOR file.
S
Select SYSTEM SETTINGS | TEMPERATURE.
2. Press the to toggle (enable or disable) the Ready Delay option.
The default is Disabled.
3. Select Time, and enter the amount of time you want the melter to remain
in the Heating state, thereby allowing for enough adhesive to melt in the
tank sufficient for production. When the Ready Time has elapsed, the
melter can enter into a Run state. Both the default and minimum is 1
minute, and the maximum is 60 minutes.
4. When done, select SAVE.
ProBlue Flex OEM User's Guide
45
Part 1129255_01