Nordson ProBlue Flex User Manual page 38

32
ProBlue Flex OEM User's Guide
Part 1129255_01
6. Select Low Pressure Alert Threshold, then enter the amount of
pressure offset below the set point before the melter enters into an Alert
condition.
Pressure Default
PSI (-)10 from
set point
(-)0.69 from
BAR
set point
kPa (-)69 from
set point
7. Select High Pressure Alert Threshold, then enter the amount of
pressure offset above the set point before the melter enters into an Alert
condition.
Pressure Default
PSI (+)10 from
set point
(+)0.69
BAR
from set
point
kPa (+)69 from
set point
8. When done, press SAVE.
NOTES:
S
The "+" symbol appears next to the High Pressure Alert threshold setting
indicating the offset or delta from the Maximum Pressure Set Point Range
setting.
S
The "-" symbol appears next to the Low Pressure Alert threshold setting
indicating the offset or delta from the Minimum Pressure Set Point Range
setting.
Minimum Maximum
(-)5 from (-)70 from
set point set point
(-)0.34 from (-)4.83 from
set point set point
(-)34 from (-) 483from
set point set point
Minimum Maximum
(+)5 from (+)70 from
set point set point
(+)0.34 (+)4.83
from set from set
point point
(+)34 from (+)483 from
set point set point
E 2020 Nordson Corporation