22
ProBlue Flex OEM User's Guide
Basic Melter Operation
Starting the Melter
Melter power switch
Part 1129255_01
Before starting the melter for the first time, confirm that the melter is fully
installed, including any required inputs and outputs, hoses, and applicators.
By default, all connected hoses and applicators are disabled, and the Master
Heater control is OFF.
1. Switch the melter power to On. The melter performs a self-check. You will
see all the LEDs and indicators briefly illuminate. If this is the first time
starting the melter, the Commissioning Wizard starts for the touch screen
version.
Shutting Down the Melter
Shut down the melter when it will not be used for an extended period of time.
1. Switch the melter Off.
The Automatic Pressure Discharge (APD) valve relieves the hydraulic
pressure back to the tank.
2. Disable the applicators as follows:
S
Air‐operated applicators: Turn Off the air supply to the applicators.
S
Electric applicators: Turn Off the applicator driver, pattern controller,
or timer.
E 2020 Nordson Corporation