Assigning Outputs - Nordson ProBlue Flex User Manual

68
ProBlue Flex OEM User's Guide
SETUP TOOL
Please select how to load a configuration file
LOAD FROM USB/COMPUTER
USE PREVIOUS FILE
CREATE NEW
SYSTEM SETTINGS
SYSTEM IO
Part 1129255_01

Assigning Outputs

1. Log into your BBconn Cloud account, then do the following:
S
Select SETUP TOOL - create or load a .NOR file.
S
Select SYSTEM SETTINGS | SYSTEM IO.
2. Select Output.
3. Standard is the default output selection and has only one output that you
can define. If you have the optional Legacy I/O kit (part number
1127717), then you have an additional three outputs that you can define.
The default Standard output is represented by the letter S. The default
for S1 (Standard Output #1 ) is Disabled.
If you have the optional Legacy I/O board installed, then select Legacy
at the top of the screen to view and change the additional three Legacy
outputs. The optional Legacy outputs are represented by the letter L. The
The default Legacy outputs are as follows:
S
L1 Legacy output #1 is Automatic Setback
S
L2 Legacy output#2 is Setback Control
S
L3 Legacy output#3 is Heater Control
4. Decide if you want to Invert (reverse the polarity) of the output. Select
Invert to change the polarity. The default is not inverted (active high).
5. When done, select SAVE.
NOTES:
S
You can assign the same output selection to multiple outputs.
S
You can assign light tower outputs using Standard or Legacy outputs.
E 2020 Nordson Corporation