Defining System Temperature Settings; Defining Smartmelt Settings - Nordson ProBlue Flex User Manual

38
ProBlue Flex OEM User's Guide

Defining System Temperature Settings

SETUP TOOL
Please select how to load a configuration file
LOAD FROM USB/COMPUTER
USE PREVIOUS FILE
CREATE NEW
SYSTEM SETTINGS
TEMPERATURE
Part 1129255_01
This section of the manual details the following Temperature System
Settings:
S
SmartMelt (Melt-on-Demand only)
S
Global (Temperature) Settings
S
Setback
S
Ready Delay

Defining SmartMelt Settings

SmartMelt is for Melt-on-Demand systems and allows the system to
automatically reduce the tank temperature by 17 C (31 F) if the fill system is
inactive for a user‐specified amount of time, thereby preventing adhesive
degradation. The system continues to maintain ready status until a fill signal
is generated again.
1. Log into your BBconn Cloud account, then do the following:
S
Select SETUP TOOL - create or load a .NOR file.
S
Select SYSTEM SETTINGS | TEMPERATURE.
2. Press the to toggle (enable or disable) the SmartMelt option. The
default is Enabled.
3. Enter the Delay Time of fill inactivity before entering into SmartMelt
mode – reducing the temperature of tank. The default is 30 minutes,
minimum 15 minutes, and maximum is 60 minutes.
4. When done, select SAVE.
5. Refer to the following Temperature System Settings sections to
continue:
S
Defining Global Temperature Settings
S
Defining Setback Settings
S
Defining Ready Delay Settings
E 2020 Nordson Corporation