Reset Key; Reset Settings - Agilent Technologies 4349B Manual

Reset Key

The Reset key resets all instrument settings and correction data to the default values. The
4349B can also be reset by sending GPIB commands
results, except in a couple of cases. The following table lists the di erence among the results of
pressing the Reset key and sending the
the settings are stored.
Data stored in the back-up memory is held for about 72 hours after powering OFF, The items
saved by the Save key or recalled by the Recall key are the same as those stored in the back-up
memory.
Data stored in the EEPROM is not a ected by powering OFF.
Item
Test voltage value Ch1
Test voltage value Ch2
Test voltage value Ch3
Test voltage value Ch4
Measurement parameter
Measurement range mode
Measurement range
Measurement time mode
Averaging rate
Trigger source
Trigger delay
Contact check
Limit data
O set data
Comparator
Comparator Limits
Display mode
Correction
Correction data
Beeper
Beeper mode
Data transfer format
Power line frequency
GPIB Address
Key lock
\ "indicates the value is the same as what's indicated to the left.
1
3-10 Function Reference
and
Table 3-1. Reset Settings
Reset Key :
0 V
0 V
0 V
0 V
R
Auto
(Auto)
30 ms
1
Internal
0 s
OFF
0
0
OFF
MAX, MIN
Measurement Data
ON
Cleared
ON
FAIL mode
ASCII
No e ect
No e ect
N/A
ON
and , with the same
command, and also lists where
1 * 1
Back-up memory
Back-up memory
Back-up memory
Back-up memory
Back-up memory
Back-up memory
Back-up memory
Back-up memory
Back-up memory
Back-up memory
Back-up memory
Back-up memory
Back-up memory
Back-up memory
Back-up memory
Back-up memory
OFF Back-up memory
OFF
No e ect OFF
OFF
4349B
Stored in
|
EEPROM
EEPROM
EEPROM
EEPROM
EEPROM
EEPROM
|
|