Agilent Technologies 4349B Manual page 223

4349B
Check that the printer is set to \Listen Always."
A1 BD TEST FAILED
20
The A1 board failed. When this error occurs during power-on test, the 4349B stops operation
and asserts the /ALARM signal on the handler interface. When this error occurs during
self-test, the 4349B continues operation and assert the /ALARM signal. Contact your nearest
Agilent Technologies oce.
LOCKOUT BY HANDLER
21
Front panel key input is disabled by the handler. The front panel key input cannot be enabled
by the front panel keys or by GPIB commands when disabled by the handler.
CH1(, CH2, CH3, or CH4) HIGH LEAKAGE
31 to 34
When the OPEN correction is performed, the leakage current is too high (100 pA or above,
100 pA or below). Check that nothing is connected to the test lead.
CH1(, CH2, CH3, or CH4) HIGH STRAY C
35 to 38
When the OPEN correction is performed, the stray capacitance is too high(75 pF or above); for
example, when you connect a coaxial test lead to a triaxial test lead, the coaxial cable is too
long.
GPIB Errors
Command error
-100
This is a generic syntax error that the 4349B cannot detect more speci c errors. This code
indicates only that a command error, as de ned in IEEE 488.2, 11.5.1.1.4, has occurred.
Invalid character
-101
A syntax element contains a character which is invalid for that type; for example, a header
containing an ampersand,
Syntax error
-102
An unrecognized command or data type was encountered; for example, a string was received
when the 4349B was not expecting to receive a string.
Invalid separator
-103
The syntax analyzer was expecting a separator and encountered an illegal character; for
example, the semicolon was omitted after a program message unit,
Data type error
-104
The syntax analyzer recognized an unallowed data element; for example, numeric or string data
was expected but block data was encountered.
.
.
Messages-3