Calculate Subsystem; Calculate 1 2 3; Calculate - Agilent Technologies 4349B Manual

CALCulate Subsystem

The CALCulate subsystem controls comparator function.
COMMAND

CALCulate

:LIMit
:PATH?
f j j
:CALCulate 1 2 3
De nes comparator output to beeper.
cause a beep when the comparison result is FAIL(High, Low or No-contact).
cause a beep when the comparison result is PASS(In).
This command is e ective when
Query response is
Note
The comparator output states of each channel are linked together. So the
function of all channels to PASS or FAIL.
f j j
:CALCulate 1 2 3
Sets or queries if the comparator output to the beeper is enabled.
, enables comparator output to the beeper as de ned by
, disables comparator output to the beeper.
When you enable the beep function,
.
Query response is
Note
The comparator output states of each channel are linked together. So the
function of all channels ON or OFF.
5-10 GPIB Reference
f j j j g
1 2 3 4
:BEEPer
[:STATe]
:CONDition
:CLEar
:FAIL?
:LOWer
[:DATA]
:STATe
:STATe
:UPPer
[:DATA]
:STATe
j g
4 :LIMit:BEEPer:CONDition
.
j g
4 :LIMit:BEEPer[:STATe]
.
PARAMETER
< Boolean >
f j g
FAIL PASS
< numeric value >
< Boolean >
< Boolean >
< numeric value >
< Boolean >
f
FAIL
command is set to
command is set to
command toggles the comparator
f j
ON OFF
command is automatically set to
command toggles the comparator
j g
PASS
and
.
j j g
1 0
command.
4349B