Agilent Technologies 4349B Manual page 126

SENSe Subsystem
[:SENSe]:CONTact:OFFSet
Set or queries an o set of contact check limit data.
Sets (
executed. See \Reading the Limit Data of Contact Check Function" in Chapter 2 for details.
Note
Set the o set value to more than 0.
< numeric value > is,
numeric -75 to 75 [PF]
MAXimum 75 [PF]
MINimum 0
[:SENSe]:CONTact:VERify
Sets or queries if the contact check function is enabled.
Where,
or Enables the contact check function.
or Disables the contact check function.
The reference data for the contact check is obtained by an OPEN correction. An OPEN
correction is required before the contact check turns on.
Query response is or .
[:SENSe]:CURRent:APERture
Sets or queries measurement time mode: 10 ms(=0.01 s), 30 ms(=0.03 s), 100 ms(=0.1 s), or
400 ms(=0.4 s).
< numeric value > is,
numeric
The following suxes can be used with < numeric value > .
: s
Query response is < numeric value > in < NR3 > format.
5-22 GPIB Reference
f j j j g <
1 2 3 4
) The o set value is set when the
f j
ON OFF
<
numeric value
0.01, 0.03, 0.1, or 0.4 (s)
: ms
>
numeric value
j j g
1 0
j
>
[MS S]
4349B
command is