Front Fascia/Headlight - Arctic Cat Altera 300 Service Manual

CLEANING AND INSPECTING
1. Clean all body components with soap and water.
2. Inspect the body and fenders for cracks.
3. Inspect threaded areas of all mounting studs for strip-
ping.
4. Inspect for missing decals.
INSTALLING
1. Place the front panel assembly onto the frame.
Loosely install the four cap screws located under the
seat.
XA065A
2. Secure the two cap screws securing the lower fascia
to the front bumper; then from within the front
bumper assembly, secure the additional two caps
screws to the frame. Tighten the cap screws from
step 1.
XA070
XA068A
3. Secure the shift knob to the shift lever using the
Allen-head screw. Secure the CVT intake tube using
the two machine screws. Connect each headlight
connector; then secure the connectors to the frame
via the locking tabs.
18
XA072
4. Secure the front body panel to the gas tank; then
install both footwells.
XA066
XA064A
5. Install the gas tank cover making sure the locating
tabs properly align with and engage the front body
panel. Secure the gas tank cover with the two rein-
stallable rivets. Install and secure the steering post
cover.
6. Place the front rack into position and secure using
the four cap screws. Install the front over-mold onto
the front rack using the self-tapping screws.

Front Fascia/Headlight

REMOVING
1. Release each locking tab securing each headlight
connector to the frame; then disconnect each connec-
tor.